Stormshield SN900 Installation Instructions Manual page 50

Inserting an extension module on SN910, SN2000 or SN3000 models
-
Using the Power button on the front panel, or from the administration interface, proceed to shut
down the Firewall,
-
Once it has fully shut down, ensure that you unplug it from any electrical power supply,
-
Remove the filler panel by unscrewing the 2 knurled screws and extract it by pulling on both
screws,
-
Present the module to be inserted, push it all the way in (push harder towards the end, then
screw in the 2 knurled screws,
-
Reconnect the Firewall to the power supply,
-
Using the Power button on the front panel, start the Firewall.
Extracting an extension module on SN910, SN2000 or SN3000 models
-
Using the Power button on the front panel, or from the administration interface, proceed to shut
down the Firewall,
-
Once it has fully shut down, ensure that you unplug it from any electrical power supply,
-
Unscrew the 2 knurled screws and extract the extension module by pulling on both screws,
-
Put back the filler panel by screwing in the 2 knurled screws,
-
Reconnect the Firewall to the power supply,
-
Using the Power button on the front panel, start the Firewall.
Inserting an extension module on SN6000 models
-
Using the Power button on the front panel, or from the administration interface, proceed to shut
down the Firewall,
-
Once it has fully shut down, ensure that you unplug it from any electrical power supply,
-
Unlock and remove the empty module in place by lifting the small catch on the bottom left, while
pulling on both handles,
-
Insert the extension module all the way in (until you hear a click to indicate that it has been
locked),
-
Reconnect the Firewall to the power supply,
-
Using the Power button on the front panel, start the Firewall.
Extracting an extension module on SN6000 models
-
Using the Power button on the front panel, or from the administration interface, proceed to shut
down the Firewall,
-
Once it has fully shut down, ensure that you unplug it from any electrical power supply,
-
Unlock and remove the module in place by lifting the small catch on the bottom left, while pulling
on both handles,
-
Put back the empty module to be inserted all the way in (until you hear a click to indicate that it
has been locked),
-
Reconnect the Firewall to the power supply,
-
Using the Power button on the front panel, start the Firewall.
Page 50 /59
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
APPENDIX D: EXTENSION MODULES (SN910/SN2000/SN3000/SN6000)
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015