Stormshield SN900 Installation Instructions Manual page 32

Installing SN2000, SN3000 and SN6000 models in a 19" cabinet
The minimum vertical space needed for installing an SN2000 or SN3000 Firewall is 1U and for installing an
SN6000, this space is 2U. The procedures for mounting lateral rails and installing appliances in racks are
described in SN2000-SN3000_rack mounting and SN6000 _rack mounting. These documents are delivered
with the SN2000/3000 and SN6000 products and are available in the Document base section in your
area (Product > Stormshield Network Firewall > User Guide > Hardware).
Installing SN150, SN200 and SN300 models in a 19" rack mount shelf
In this non-standard installation, allow a height of more than 1U due to the thickness of the shelf and the
presence of rubber feet below the appliance. Proceed as follows:
Using screws and caged nuts (not provided with the appliance), fasten the shelf to the vertical rails
located at the front of the cabinet.
Once the shelf has been installed, you can place one or two appliances on it (no additional fastening is
needed).
If you are installing two Firewalls on the same rack mount shelf, you will need to leave
enough space between the Firewalls to avoid obstructing the flow of air from the sides.
Page 32 /59
WARNING
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
Installing SN910 model in a 19"
cabinet
The minimum vertical space needed for installing an SN
Firewall is 1U.
Once the brackets have been installed, you can fasten
the Firewall to the vertical rails located at the front of
your cabinet using screws and the caged nuts (not
provided with the appliance).
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
INSTALLATION PRECAUTIONS
Secure