Stormshield SN900 Installation Instructions Manual page 21

SN2000 and SN3000 models
For more information on Ethernet interfaces, please refer to the section
chapter INSTALLATION PRECAUTIONS.
Front panel: connectors and LEDs
1
1. The Power button allows switching the Firewall on or off.
2. The Power and Online LEDs (from bottom to top).
3. This button is for resetting to factory configuration (defaultconfig).
4. SSD racks for log storage (1 on SN2000 models, 2 in RAID 1 on SN3000 models).
5. The LEDs on SSD racks confirm whether the SSD has been accessed (blue LED on the right)
Rear panel: connectors
1 2
1. Two ports dedicated to the management of the appliance or a High Availability configuration
2. The serial port allows accessing the appliance in console mode; it is possible to log on to the
3. Four USB 3.0 ports that can be used for secure configurations or upgrades. You may also
4. The VGA port allows connecting a monitor.
5. The mini-din PS2 port allows connecting a keyboard.
6. The product's on/off switch (SN2000 only).
7. A mains socket (SN2000) or two mains sockets (SN3000) for redundant power supplies.
Page 21 /59
1
2
2 3 4
and installed (green LED on the left).
3 4 5
(MGMT1 and MGMT2)
Firewall directly using a computer. The default baud rate on these models is 9600 baud
(8N1).
plug in a USB key, USB keyboard or approved USB modem.
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
PRESENTATION OF "SN" MODELS
Connecting to the network
5
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
in the
1
Online LED (green)
2
Power LED (yellow)
6
7