Stormshield SN900 Installation Instructions Manual page 20

SN910 model
For more information on Ethernet interfaces, please refer to the section
chapter INSTALLATION PRECAUTIONS.
Front panel: connectors and LEDs
1
1. This button is for resetting to factory configuration (defaultconfig).
2. The serial port allows accessing the appliance in console mode; it is possible to log on to the
Firewall directly using a computer. The default baud rate on these models is 9600 baud (8N1).
3. Two USB 3.0 ports that can be used for secure configurations or upgrades. You may also plug in a
USB key, USB keyboard or approved USB modem.
4. The Power and SSD activity LEDs (from top to bottom).
5. The Reset button: electrically resets the Firewall.
Rear panel: connectors
1. A mains socket.
2. The product's on/off switch.
3. The USB 2.0 port can be used for secure configurations or upgrades. You can also connect a USB
key, a USB keyboard or an approved USB modem
4. The VGA port allows connecting a monitor.
Page 20 /59
1 2 3
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
PRESENTATION OF "SN" MODELS
Connecting to the network
1
2
2 3 4 5
4
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
in the
1
Power LED (green)
2
SSD activity LED (red)