Hold down the button for about 5 seconds, until you see the Online and Status LEDs blink and/or until you
hear an audible signal. The reset procedure will automatically be launched. After a few minutes the initial
settings will be recovered and the Firewall will reboot.
SN6000 Model
It is possible to restore the factory configuration of an SN6000 only by connecting in console mode. Type the
following command:
The reset procedure will automatically be launched. After a few minutes, the initial settings will be recovered
and the Firewall will reboot.
Page 45 /59
SN910 model
defaultconfig –f -r –p
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
APPENDIX B: RESETTING THE FIREWALL
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
SN2000 and SN3000 models