Appendix E: Fiber Transceivers - Stormshield SN900 Installation Instructions Manual

APPENDIX E: FIBER TRANSCEIVERS

REMINDER
 SN900 and SN910 models offer two sockets for SFP transceivers by default.
 Use only Stormshield Network-approved SFP (1Gbps) or SFP+ (1/10Gbps) transceivers available
in the catalogue.
 Only LC fiber optic connectors are supported.
Stormshield Network approved Ethernet transceivers
SFP Transceiver, 1000Base-SX, multi-mode fiber:
Ethernet 1000Base-SX, requires multi-mode fiber.
Maximum typical distance supported (subject to optimum quality): 550m
SFP Transceiver, 1000Base-LX, single-mode fiber:
Ethernet 1000Base-LX, requires single-mode fiber.
Maximum typical distance supported (subject to optimum quality): 10km
SFP+ Transceiver, 10GBASE-SR/1000Base-SX , multi-mode fiber:
Ethernet 10GBASE-SR/1000Base-SX, requires multi-mode fiber.
Maximum typical distance supported (subject to optimum quality):
300m to 10Gbps, 550m to 1Gbps.
SFP+ Transceiver, 10GBASE -LR, single-mode fiber:
Ethernet 10GBASE-LR/1000Base-LX, requires single-mode fiber.
Maximum typical distance supported (subject to optimum quality): 10 km
NOTE
Only 1 Gbps or 10 Gbps transceivers distributed by Stormshield Network are supported. Twinax
cables (10 Gbps) may also be used. Contact your Stormshield partner if you have a specific
requirement.
Installation
IMPORTANT
The transceiver and the optic fiber are equipped with a connector plug. When you plug this optic fiber
into the transceiver, remove the connector plugs and keep them away from dust for later use.
IMPORTANT
Do not exceed the bending radius indicated in your optic fiber
specifications.
Page 51 /59
Proceed as follows to install your transceiver:
If the socket in which you would like to install the transceiver has a protective cover,
remove it.
Insert the transceiver, then plug in the optic cable corresponding to this transceiver.
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
FIBER CONNECTOR
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
APPENDIX E: FIBER TRANSCEIVERS
SN910, SN2000,
SN900
SN3000 and SN6000
supported
supported
not supported
not supported
supported
supported
supported
supported