Stormshield SN900 Installation Instructions Manual page 22

SN6000 model
For more information on Ethernet interfaces, please refer to the section
chapter INSTALLATION PRECAUTIONS.
Front panel: connectors and LEDs
1
2
3
1. The Power button allows switching the Firewall on or off.
2. The Reset button: electrically resets the Firewall.
3. The USB 2.0 port can be used for secure configurations or upgrades. You can also connect a
Rear panel: connectors
1 2
1. SSD racks for log storage (2 in RAID 1). The LEDs on SSD racks confirm whether the SSD has
2. Two mains sockets for redundant power supplies.
3. The serial port allows accessing the product in console mode; it is possible to connect the
4. A network port dedicated to the administration of the appliance via IPMI. Please refer to the
5. Four USB 2.0 ports that can be used for secure configurations or upgrades. You may also
6. Two network ports dedicated to the management of the appliance or a High Availability
7. The VGA port allows connecting a monitor.
Page 22 /59
1 2
USB key, a USB keyboard or an approved USB modem.
3 4
been accessed (bottom blue LED) and installed (top green LED).
Firewall directly from a computer. The default baud rate on this model is 9600 baud (8N1).
appendix for information on the configuration and administration via
plug in a USB key, USB keyboard or approved USB modem.
configuration (from left to right: MGMT1 and MGMT2).
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
1
Red LED: indicates overheating or hardware failure (fans)
2
Green Power LED: indicates whether the Firewall is powered up.
5 6 7
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
PRESENTATION OF "SN" MODELS
Connecting to the network
IPMI.
in the