Table of Contents
Advertisement
Sequencing of modules
When extension modules are added or removed, ports will be reordered according to the order shown below.
SN910 Model
SN2000 and SN3000 Models
SN6000 Model:
Procedure for removing/ inserting extension modules
No specific licenses are required for adding extension modules.
IMPORTANT
Extension modules must only be removed or inserted on appliances that have fully shut down and
which are necessarily unplugged from any electrical power supply.
Specific instructions on the location of modules are as follows:
-
Modules have to be inserted from left to right starting with the top row.
-
There must not be any empty slots between two modules in the same row.
Furthermore, on the SN6000 model, in order to enhance your product's performance, you are advised to
spread out the network modules over 2 rows, without leaving any empty slots between two modules in the
same row. This makes it possible to balance the two CPUs' load. The first row of modules and the 2 network
ports located on the rear of the appliance are managed as a priority by the first CPU and the second row by the
second CPU.
REMINDER
In cases where modules are added subsequently in row 1, the interfaces of the modules in row 2 will
be automatically re-ordered.
Page 49 /59
APPENDIX D: EXTENSION MODULES (SN910/SN2000/SN3000/SN6000)
N°3
N°1
N°2
N°4
N°5
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
N°2
N°1
N°1
N°2
N°3
N°6
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
N°3
N°7
Hide quick links:
Advertisement
Table of Contents
