5-Bin Mailbox Output Bin Roller Removal; 5-Bin Mailbox Output Bin Sensors Removal - Lexmark X792 7562-4xx Service Manualv

5-bin mailbox output bin roller removal

1.
Remove the mailbox option from the printer.
2.
Remove the 5-bin mailbox output deflector for the roller you want to remove.
3.
Rotate the clips forward that are holding the roller in place.
4.
Lift the roller out of the mailbox.

5-bin mailbox output bin sensors removal

See "5-bin mailbox assembly (interior)" on page 7-49
1.
Remove the mailbox from the printer.
2.
Remove the rear cover. See
3.
Press in the tabs to pop out the sensor you need to replace.
4.
Disconnect the cable to remove the sensor.
Installation note: When you put the sensor in place, be sure the side with the cable connector faces the printer
circuit board.
for the part number.
"5-bin mailbox rear cover removal" on page
7562
4-327.
4-325
Repair information
Previous
Next
Go Back