System Board Cage With Board Removal - Lexmark X792 7562-4xx Service Manualv

3.
Determine if the problem is resolved. Do not perform a normal POR until you are sure you have resolved
the problem.
•
If the problem is not resolved, then turn the printer off and reinstall the old part.
•
If the problem is resolved, then turn the printer off and turn it back on without holding any buttons
(perform a normal POR).
4.
Verify that the input sources are recognized:
a.
From the Home screen, navigate to:
Menus > Paper Menu > Paper Size/Type
b.
Make sure all installed options are listed.
5.
Verify that the output options are recognized:
a.
From the Home screen, navigate to:
Menus > Paper Menu > Bin Setup > Output Bin
b.
Make sure all installed options are listed.

System board cage with board removal

1.
Remove the flatbed scanner assembly. See
2.
Remove the LVPS. See
3.
Remove two screws (A) to remove the RIP card shield from the system board.
"Flatbed scanner assembly removal" on page
"Low-voltage power supply (LVPS) removal" on page
A (88A0232)
7562
4-226.
4-81.
4-157
Repair information
Previous
Next
Go Back