Finisher Stapler Unit Assembly Removal - Lexmark X792 7562-4xx Service Manualv

7562
6.
Remove two screws (C).
7.
Pull up to remove the top cover.

Finisher stapler unit assembly removal

1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Remove two screws (A) to remove rear cable from the stapler unit assembly, and then remove the other
three cables (B) attached to the assembly.
4.
Remove the three screws (C).
5.
Remove the stapler unit assembly.
Installation note: Be sure to secure the ground cable with the front screw.
4-360
Service Manual
"Finisher or stacker rear cover removal" on page
Previous
Next
Go Back
4-346.