Table of Contents
Advertisement
7562
ADF
Sensor (ADF long media)
The document length in the slow scanning direction is detected by this sensor.
Sensor (ADF width 1), Sensor (ADF width 2), Sensor (ADF width 3), Sensor (ADF
width 3)
The document length in the fast scanning direction is detected by the combination of these three sensors
detecting the position of the tray on which the document is set.
Sensor (ADF document set)
A sensor that detects the presence or absence of a document on the ADF document tray.
ADF Document Set LED
An LED that illuminates when a document is set on the ADF Document Tray.
Switch (ADF top door interlock)
A switch that detects whether the ADF top door assembly is open.
ADF controller card assembly
A card that controls the ADF unit assembly. The ADF controller card assembly is connected to and controlled
by the Scanner controller card assembly.
Sensor (ADF sheet through)
The ADF sensor (ADF sheet through) is installed immediately downstream from the Feed/pick roll assembly to
detect completion of document feed.
Sensor (ADF 1st scan)
The ADF sensor (ADF 1st scan) is installed just upstream of the scanning surface and is used to for scanning
timing operations.
Sensor (2nd scan)
The ADF sensor (ADF 1st scan) is installed just down stream of the scanning surface and is used to for
scanning timing operations.
Sensor (ADF media exit)
The sensor (ADF media exit) is used to detect when scanned media has exited the ADF.
ADF feed motor assembly
The feed motor assembly is a stepping motor that rotates the pick roll and feed roll in the reverse direction
(CCW direction) and rotates the ADF transport roll assembly in the normal direction (CW direction).
When this motor rotates in the reverse direction, the ADF transport roll assembly stops.
3-50
Service Manual
Previous
Next
Go Back
Advertisement
Table of Contents
