Bootp Client Configuration Example - H3C S5810 Series Operation Manual

Ethernet switches

Hide thumbs Also See for S5810 Series:

Table of Contents

BOOTP Client Configuration Example

Network requirement

in,Figure 3-1

obtains an IP address from the DHCP server by using BOOTP.

Figure 3-1 BOOTP network diagram

10.1.1.126/25

Configuration procedure

The following describes only the configuration on Switch A serving as a client.

# Configure VLAN-interface 1 to dynamically obtain an IP address from the DHCP server.

<SwitchA> system-view

[SwitchA] interface vlan-interface 1

[SwitchA-Vlan-interface1] ip address bootp-alloc

Switch A's port belonging to VLAN 1 is connected to the LAN. VLAN-interface 1

Table of Contents