H3C S5810 Series Operation Manual page 199

To do...
Enter system view
Create a remote source
mirroring group
In system view
Configure
mirroring
ports
In interface
view
In system view
Configure
the reflector
In interface
port
view
Configure the remote probe
VLAN
When configuring the mirroring ports, note that:
The mirroring ports and the reflector port must be located on the same device.
To ensure device performance, do not assign the mirroring ports to the remote probe VLAN.
When configuring the reflector port, note that:
Use the command...
system-view
mirroring-group groupid
remote-source
mirroring-group groupid
mirroring-port mirroring-port-list
{ both | inbound | outbound }
interface interface-type
interface-number
[ mirroring-group groupid ]
mirroring-port { both | inbound |
outbound }
quit
mirroring-group groupid
reflector-port reflector-port-id
interface interface-type
interface-number
mirroring-group groupid
reflector-port
quit
mirroring-group groupid
remote-probe vlan rprobe-vlan-id
1-6
Remarks
—
Required
Required
In system view, you can
configure a list of mirroring
ports to the mirroring
group at a time.
In interface view, you can
assign only the current
interface to the mirroring
group. To monitor multiple
ports, repeat the step.
Required
Use either approach.
Required