H3C S5810 Series Operation Manual page 708

Ethernet switches

Hide thumbs Also See for S5810 Series:

Table of Contents

channel name

Configurations for the seven output destinations function independently and take effect only after the

information center is enabled.

Outputting system information by source module

The system is composed of a variety of protocol modules, board drivers, and configuration modules.

The system information can be classified, filtered, and output according to source modules. You can

use the info-center source ? command to view the supported information source modules.

Default output rules of system information

The default output rules define the source modules allowed to output information on each output

destination, the output information type, and the output information level as shown in

indicates that by default and in terms of all modules:

All log information is allowed to be output to the log file; log information with severity level equal to

or higher than informational is allowed to be output to the log host; log information with severity

level equal to or higher than warning is allowed to be output to the console, monitor terminal, and

log buffer; log information is not allowed to be output to the trap buffer and the SNMP module.

All trap information is allowed to be output to the console, monitor terminal, log host and log file;

trap information with severity level equal to or higher than warning is allowed to be output to the

trap buffer and SNMP module; trap information is not allowed to be output to the log buffer.

All debugging information is allowed to be output to the console and monitor terminal; debugging

information is not allowed to be output to the log host, log file, log buffer, trap buffer and the SNMP

Table 1-3 Default output rules for different output destinations

Default output destination

Not specified

Receives log, trap, and

debugging information.

Receives log, trap, and

debugging information.

Chapters

Table of Contents