H3C S5810 Series Operation Manual page 447

Figure 1-9 Configure AAA for SSH users by a RADIUS server
Configuration procedure
1) Configure the RADIUS server. ( iMC )
This example assumes that the RADIUS server runs iMC PLAT 3.20-R2602 or iMC UAM 3.60-E6102.
# Add an access device.
Log into the iMC management platform, select the Service tab, and select Access Service > Service
Configuration from the navigation tree to enter the Service Configuration page. Then, click Add to
enter the Add Access Device window and perform the following configurations:
Set both the shared keys for authentication and accounting packets to expert
Specify the ports for authentication and accounting as 1812 and 1813 respectively
Select Device Management Service as the service type
Select H3C as the access device type
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2
Click OK to finish the operation
1-38