Outputting System Information To The Snmp Module - H3C S5810 Series Operation Manual

To do...
Configure the output rules of
the system information
Configure the format of the
timestamp

Outputting System Information to the SNMP Module

The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For details, refer to SNMP
Configuration in the System Volume.
Follow these steps to configure to output system information to the SNMP module:
To do...
Enter system view
Enable information center
Name the channel with a
specified channel number
Configure the channel through
which system information can
be output to the SNMP module
Configure the output rules of
the system information
Use the command...
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Use the command...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center snmp channel
{ channel-number |
channel-name }
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
1-12
Remarks
Optional
Refer to Default output rules of
system information.
Optional
The time stamp format for log,
trap and debugging information
is date by default.
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2 for default
channel names.
Optional
By default, system information
is output to the SNMP module
through channel 5 (known as
snmpagent).
Optional
Refer to Default output rules of
system information.