Configuring Web User Accounts In Batches - H3C S5810 Series Operation Manual

perform SNMP-related configurations on the management device and synchronize them to the member
devices on the whitelist. This operation is equal to configuring multiple member devices at one time,
simplifying the configuration process. Follow these steps to configure the SNMP configuration
synchronization function:
To do...
Enter system view
Enter cluster view
Configure the SNMP
community name shared by a
cluster
Configure the SNMPv3 group
shared by a cluster
Create or update information of
the MIB view shared by a
cluster
Add a user for the SNMPv3
group shared by a cluster
The SNMP-related configurations are retained when a cluster is dismissed or the member devices
are removed from the whitelist.
For information about SNMP, refer to SNMP Configuration in the System Volume.

Configuring Web User Accounts in Batches

Configuring Web user accounts in batches enables you to configure on the management device the
username and password used to log in to the devices (including the management device and member
devices) within a cluster through Web and synchronize the configurations to the member devices in the
whitelist. This operation is equal to performing the configurations on the member devices. You need to
enter your username and password when you log in to the devices (including the management device
and member devices) in a cluster through Web.
Follow these steps to configure Web user accounts in batches:
Use the command...
system-view
cluster
cluster-snmp-agent
community { read | write }
community-name [ mib-view
view-name ]
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ]
cluster-snmp-agent mib-view
included view-name oid-tree
cluster-snmp-agent
usm-user v3 user-name
group-name
[ authentication-mode { md5 |
sha } auth-password ]
[ privacy-mode des56
priv-password ]
1-17
Remarks
—
—
Required
Required
Required
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
Required