Advertisement
9.
Place the 1/16" F15 former flat on your work surface. Press the 1/16" F13 into place as shown in the image below. Make sure they
are at 90 degrees to each other and secure with thin CA.
10. Do not glue anything until you are told to do so. Press the 1/8" F2 assemble into the fuselage RIGHT, making sure the text is facing
FORWARD. THIS IS IMPORTANT. Press the 1/16" F9, 1/16" F10, 1/16" F11, 1/16" F12, and 1/16" F13 into place but DO NOT
glue them yet. Press the assembled F14/F15 piece into place as shown in the image below. DO NOT GLUE ANYTHING YET.
11. Assemble the fuselage LEFT to the assembly from step 10. DO NOT GLUE anything yet. Be careful and make sure all tabs are
fully pressed in/together and that everything is aligned properly. See the image below for what it will look like when you are done.
Be gentle when pressing the side onto the formers. If something is tight, use light sandpaper on the joint.
12. Assemble 1/8" Balsa F1 to the fuselage assembly, making sure the text is facing FORWARD. This is IMPORTANT! Do NOT glue
it in yet. Use low-tac tape to hold it in place if you need.
Copyright 2005-2011 Mountain Models
6
Advertisement
