Advertisement
13. Make sure all parts are fully seated and aligned. Place the wing on your work surface, left side down, with the tabs on the rear of
the ribs resting on the work surface. Press down on the upper spar cap to make sure the caps are seated to the spar, and use thin CA
to glue the lower spar cap to the spar. Use thin CA to glue all joints on the left wing half. Repeat for the right side of the wing.
14. Locate and remove the 1/16" rear pieces marked "B". These are the bottom caps for the rear of the wing. The other 2 that look
similar are the top ones. With the left wing panel flat on the building surface, set the top one in place as shown in the image below.
Make sure it is fully in the notch in the ribs, and secure it with thin CA. Repeat for the other side of the wing. The caps do not need
to be flush to the top the rear spar, but can sit at a "V" there.
15. Turn the wing over and install the top rear spar caps on each wing half, securing them with thin CA. The spar caps should be flush
in the center section as shown below.
16. Locate and remove the W20 parts from the 1/16" balsa sheet. Install them as shown below, making sure they are pushed fully into
the wing ribs, and secure with thin CA.
Copyright 2005-2011 Mountain Models
19
Advertisement
