Advertisement
Kit Contents:
1.
CAD Plan Sheet
2.
Instruction Manual
3.
Laser Cut Balsa and Plywood Sheets (Bagged)
4.
Vac-Formed Plastic Parts
•
Clear Canopy
•
Cockpit with Seat
•
Cowling
•
Exhaust Stacks (Left and Right)
•
Radiator Scoop (Top and Bottom)
5.
Large Hardware Bag
•
2 ea. 1-3/4" DuBro Wheels
•
2 ea. Main Gear Wire (3/32" Dia. x 7")
•
Pushrod Wire (0.047" Dia. x 18")
•
Velcro Set, 4" (Loop and Pile)
•
Velcro, Double Sided, 8"
•
Thin Plastic Tube
6.
Small Hardware Bag
•
2 ea. Landing Gear Wheel Bushings (Aluminum Tube)
•
2 ea. Fixed Gear Wheel Keepers (Star Locks)
•
2 ea. Retract Gear Wheel Keepers (Plastic Tube)
•
2 ea. 4-40 T-Nuts
•
2 ea. 4-40 x 1" Nylon Bolts
•
½" Tail Wheel
•
Rare Earth Magnet
•
3/8" Dia. Steel Washer
•
E-Z Hinge Material
•
Screws, Gear Mount (8)
7.
Pull-Pull Parts Bag
•
6 ea. Micro Servo Connector
•
6 ea. Servo Connector Backer
•
6 ea. Servo Connector Lock Screw
•
4 ea. Cotter Pin
•
8 ft. Pull-Pull Line
8.
Decal Bag
•
2 ea. Stars and Bars for Fuselage Sides
•
2 ea. Stars and Bars for Wings
Recommended Items for Finishing:
1.
1 Roll Lightweight Covering (So-Lite or Similar)
2.
Extra Covering or Trim Sheets for Details as Needed
3.
Paint for Finishing Plastic Parts
4.
GWS 50mm 2 or 4 Blade Spinner (or Similar)
5.
Optional: GWS "Blue" Retracts
Suggested Electronics:
1.
4 Channel Transmitter Minimum (5 minimum for retracts)
2.
4 ea. Sub Micro Servos (HS-55, GWS Naro, or equivalent)
3.
Optional: HS-55 (or similar in size and torque for retracts)
4.
Y-Splitter for Aileron Servos (or 6ch RX with appropriate transmitter)
5.
Optional: 2 ea. 6" Servo Extensions (if using servos with short wires)
6.
Micro Receiver, (4 channel minimum, 5 channel minimum for retracts)
Copyright 2005-2011 Mountain Models
2
Advertisement
