Advertisement
5.
Push the F28 parts into the completed F7 former as shown in the image below. Make SURE that the formers are positioned like
they are in the image and the blind nuts are facing the right direction, otherwise, they won't do their job of keeping the wing in
place! After you have double checked that they are correct, make sure they are at a 90 degree angle to F7, and secure them with
thin CA.
6.
Press the F7 assembly from the last step into the F6 as shown in the image below, with side flush with the magnet facing away
from F7. Make sure that the triangular F28 parts are facing to the long end of F6 as shown. After you double check that they are
oriented properly, make sure they are at a 90 degree angle to each other and secure with thin CA.
7.
Press the 3/32" F5A and F8 parts onto the ends of F6, making sure they are on the correct ends. After everything lines up properly,
make sure the formers are 90 degrees to F6 and secure with thin CA.
8.
Do not glue anything until you are told to do so. Take the assembly from the previous step and carefully press it into place on the
fuselage RIGHT side as shown in the image below. DO NOT GLUE ANYTHING at this time.
Copyright 2005-2011 Mountain Models
5
Advertisement
