Advertisement
20. Locate and remove the W19 wing tip parts from the 3/32" balsa sheet. Install them as shown in the image below, making sure the
tabs are pushed in as far as they can go. Secure the parts with thin CA.
21. Locate and remove the RT3 and RT4 parts from the 3/16" balsa sheet. Install them as shown below. RT3 goes in the front, RT4
goes in the back. Make sure they are pushed in fully and secure them in place with thin CA.
22. Locate and remove the W25 and W26 parts from the 3/16" balsa sheet. Install them as shown below. Make sure you have them
oriented properly. Do NOT glue them at this time.
Copyright 2005-2011 Mountain Models
21
Advertisement
