Advertisement
7.
Locate and remove the R6, R7, and R8 parts from the half sheet of 1/16" balsa. Assemble them as shown below, but do NOT glue
them in yet.
8.
Assemble the 1/8" R5 piece as shown below. The engraved line down the center of the part should be facing the outside. The line is
a sanding reference. For later on. Make sure all the tabs are fully pressed into it, being careful not to damage the 1/16" ribs. Make
sure all parts are fully seated, the rudder is straight, and secure all joints with thin CA.
9.
Assemble the 1/8" R9 parts as shown below, 1 on each side of the rudder, making sure the slot is lined up on the rudder and R9
parts. Secure in place with thin or thick CA.
Copyright 2005-2011 Mountain Models
13
Advertisement
