Advertisement
3.
Press the A5 1/8" balsa piece into place on the other end of A6 as shown in the image below. Make sure it is fully in place and
secure it with thin CA.
4.
Dry fit the A9 1/64" plywood piece as shown in the image below. Lightly sand the edges if needed to fit between the end ribs. If it
fits nicely, place a bead of thick CA down the surface and apply it to A6.
5.
Press the A4 1/16" balsa part into place as shown below. Secure it with thin CA.
6.
Carefully press the A7 1/8" balsa part into place as shown in the image below. Be careful not to damage the part as you are putting
it in place. Make sure it is pressed into place properly with the ribs flush to the outside. The outer bottom of A7 will be aligned with
the tabs on A6, and on the bottom, the back edge of A7 will be flush with the bottom of A6. When it is lined up right, secure the
joints with thin CA.
7.
Repeat steps 2 through 7 for the other aileron,. MAKE SURE you make a LEFT and a RIGHT aileron. Leaving the first one on the
plan sheet will keep you from making 2 of the same side.
8.
Set the ailerons aside in a safe place and continue with the next section.
Copyright 2005-2011 Mountain Models
24
Advertisement
