Mountain Models P-51 Mustang Assembly Manual page 20

1/12 scale electric park flyer

17. Locate and remove the W22 part from the 3/32" balsa sheet. Line up the holes with W21 and secure with CA. Make sure the holes

line up! Sand the back end of this part to match the ribs on either side.

18. Locate and remove the W18 part from the 3/16" balsa sheet. Press it into place as shown in the image below and secure with thin

CA.

19. Locate and remove the W30 and W31 parts from the 1/8" balsa sheet. Install them as shown below, making sure they are on the

right side (W30 in front and W31 behind the spar) and secure them with thin CA. Make sure they are pressed down all the way.

Table of Contents