Advertisement
4.
Locate and remove the V8 and V9 parts on the ½ sheet of 1/16" balsa. Assemble them as shown below, but do NOT glue them yet.
5.
Press V5 into V6, making sure the tab is fully pressed in. Being careful not to damage the 1/16" ribs, press V4 into place, but do
NOT glue it yet. Make sure all of the parts are fully pressed together, the vertical fin is straight, and secure all joints with thin CA.
6.
Locate and remove the R1 to R5 parts from the same 1/8" sheet used in the Vertical fin. They are all in the section next to the
vertical fin parts. Assemble R1, R2, R3, and R4 over the plan sheet and secure with thin CA as shown in the image below.
Copyright 2005-2011 Mountain Models
12
Advertisement
