Maintenance/Repair; Disposal; Disposal Information; Information On Re-Use - Otto Bock Avantgarde CV Instructions For Use Manual

• Conduct a sitting test with the user of the product. Pay special attention to proper positioning according to
medical considerations.
• The user and any attendants must be instructed in safe use of the product. In particular, the enclosed instruc­
tions for use (user) are to be used.
• The instructions for use (user) must be issued to the user/attendant during handover of the wheelchair.

8 Maintenance/Repair

The manufacturer recommends regular maintenance of the product every 12 months.
More information on cleaning/disinfection and maintenance/repair can be found in the instructions for use (user).
The service manual contains detailed information on repairs.

9 Disposal

9.1 Disposal information

In case of disposal, all components of the product must be disposed of in accordance with the respective national
environmental laws.

9.2 Information on re-use

CAUTION
Use of used seat upholstery
Functional and hygiene risks for the skin
► Replace the seat upholstery if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or cars, products that are being re-used are subject to increased strain. The
characteristics and specifications must not change to an extent that would endanger the safety of patients and, if
applicable, third parties during the lifespan of the product.
Based on market observations and the current state of technology, the manufacturer has calculated that the
product can be used for a period of 4 years, provided that it is used properly and that the service and maintenance
instructions are observed. Storage times at the dealer or with paying parties are not included in this period. It
should be emphasised, however, that the product is reliable far beyond this defined period of time if it is cared for
and maintained properly.
The product must first be thoroughly cleaned and disinfected before it can be re-used. Then the product must be
examined by an authorised specialist to check the condition and to look for wear and possible damages. Any worn
and damaged components as well as components that do not fit or are not suitable for the new user must be
replaced.
Detailed information on the replacement of parts and details of tools required and prescribed service intervals can
be found in the service manual.

10 Legal Information

10.1 Liability

The manufacturer's warranty applies only if the device has been used under the conditions and for the purpose
described. The manufacturer recommends that the device be used and maintained according to the instructions for
use.
The manufacturer is not responsible for damages caused by components and spare parts not approved by the
manufacturer. Repairs must be carried out exclusively by authorised dealers or by the manufacturer.

10.2 CE Conformity

This device meets the requirements of the 93 / 42 / EEC guidelines for medical devices. This device has been clas­
sified as a class I device according to the classification criteria outlined in appendix IX of the guidelines. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to appendix
VII of the guidelines.
Avantgarde CV/CS/CLT
Maintenance/Repair
Ottobock | 29