Repositioning The Front Wheel - Otto Bock Avantgarde CV Instructions For Use Manual

1) Remove the protective cap.
2) Slightly loosen the Allen head screw on the eccentric (see Fig. 18).
3) Slightly loosen the Allen head screws on the inside of the frame (see Fig. 19).
4) Position the spirit level (see Fig. 20, item 1).
5) Adjust the caster angle to 90° with a wide flat screwdriver. The spirit level must be in the centre position to do
so (see Fig. 20, item 2).
6) Tighten the Allen head screw on the eccentric to 8 Nm (CLT: 5.5 Nm) (see Fig. 21).
7) Tighten the Allen head screws on the inside of the frame to 23 Nm (CLT: 13 Nm).
→ The threaded axle on both caster wheel adapters must be positioned vertically.

6.4.2 Repositioning the front wheel

INFORMATION
Observe the seat height table in the "Technical Data".
The height of the seat front is adjusted via the row of holes in the fork and via the front wheel diameter.
1) Loosen the nut of the screw shaft (see Fig. 22).
2) Remove the screw shaft and spacers (see Fig. 23).
3) Remove the front wheel.
4) Insert the screw shaft with the 1st spacer bush offset (see Fig. 24, item 1).
5) Install the front wheel.
6) Push on the 2nd spacer bush (see Fig. 25, item 1).
7) Tighten the nut of the screw shaft to 8 Nm.
→ After adjusting, the left and right front wheel must have the same vertical position in the front wheel fork.
Avantgarde CV/CS/CLT
18
20
Adjustments
19
21
Ottobock | 15