Installing The Anti-Tipper - Otto Bock Avantgarde CV Instructions For Use Manual

Adjustments
2) Hold the vertical accessory mount against the inside of the frame tube with the rounded side towards the frame
tube. Place the rounded side on the frame tube (see Fig. 61).
3) Bolt on the accessory mount:
→ Insert 2 x 1 screw with washer from the outside through the frame tube (see Fig. 62, item 1).
→ Thread 2 x 1 nut from above into the profile of the vertical accessory mount (see Fig. 62, item 2).
→ Hold the nuts and tighten the screws from the outside to 7 Nm.

6.10.2 Installing the anti-tipper

INFORMATION
Note that, for a seat inclination ≥ 3 cm, the 481A64=SV172 Conversion Set must also be installed with the com­
bination of the anti-tipper, right, and the crutch holder, right. This conversion is necessary to stop the anti-tipper
when deactivated from striking against the frame.
The anti-tipper can be installed at 5 positions on the vertical accessory mount (see Fig. 63, item 1).
1) Push the anti-tipper tube from below into the vertical accessory mount.
2) Tighten the anti-tipper tube in the vertical accessory mount with the Allen head screw to 7 Nm (see Fig. 63,
item 2).
26 | Ottobock
59
61
60
62
Avantgarde CV/CS/CLT