Table of Contents
Advertisement
7.11
Disassembly and transport
The wheelchair must be prepared for transport in a passenger vehicle�
1) Remove the rear wheels (see page 18)�
INFORMATION: The rear wheels can be safely stowed in a bag (optional) for transport.
2) Place the disassembled wheelchair and components safely in the vehicle�
3) Securely reattach the rear wheels during reassembly�
7.12
Care
7.12.1 Cleaning
1) Clean the padding and upholstery with warm water and a mild detergent�
2) Remove any spots with a sponge or a soft brush�
3) Rinse with clear water and let the components dry�
Important information on cleaning
• Do not use any aggressive cleaners, solvents or hard brushes, etc�
• Clean plastic parts, frame parts and the chassis and wheels with a mild cleaner and a damp cloth� Dry thoroughly
afterwards�
• Do not immerse in water� Components are not machine-washable�
• To care for aluminium or chrome, use conventional aluminium or chrome care and cleaning products�
• Do not spray the product with a pressure washer�
7.12.2 Disinfection
1) Thoroughly clean the pads before disinfecting�
2) Wipe all parts of the wheelchair with a disinfectant�
Important information about disinfecting
• If the product is used by more than one person, using a conventional disinfectant is required�
• Only use colourless water-based disinfectants� Observe the instructions for use provided by the manufacturer�
8
Maintenance and repair
8.1
Maintenance
• The function of the product should be checked before each use�
• The product should not be used if defects are noted� This applies in particular in case of altered driving cha-
racteristics as well as problems with the user's seating position or the stability of the seat� Inform the qualified
personnel promptly for the rectification of defects�
• This also applies if loose, worn, bent or damaged components, cracks in the frame or broken frame components
are identified�
• Some maintenance tasks within a defined scope can be completed directly by the user (see the sections "Main-
tenance tasks" and "Further maintenance information")�
• The manufacturer also recommends a regular inspection every 12 months by the dealer who issued the product
to you or the manufacturer's service (see the section "Inspection")�
• Failure to maintain the product can lead to serious or life-threatening injury to the user of the product�
• Servicing and repairs may only be carried out by qualified personnel or the manufacturer� This will ensure that
only Ottobock spare parts are used for repairs�
8.1.1
Maintenance tasks
The functions described below must be checked by the user at the specified intervals:
Invader Pointer
Maintenance and repair
Ottobock | 23
Advertisement
Table of Contents
