Table of Contents
Advertisement
FOREWORD
Your decision to purchase a Protector P500S Wirefree
Alarm System represents a major and sensible step
towards total protection of your premises, its contents
and its occupants.
The Protector P500S Wirefree Alarm System complies
with the requirements of BS6799 Class 1, 2 & 3 for
Wire-free Alarms. All components are designed and
manufactured to provide a high standard of security
protection and long, reliable service. In addition, the
radio devices are tested and approved by the Radio
Regulatory division of the Department of Trade and
Industry (DTI) to ensure that they will not interfere with
other radio equipment. No radio licence is required,
however, the approved radio frequency is not protected
from interference and may be withdrawn from use at
any time subject to the DTI giving users an appropriate
notice period.
The Protector P500S Wirefree Alarm System is
purposely designed for installation by non-experienced
people using only conventional domestic tools.
However, it is essential that the installer reads and fully
understands the advice and procedures contained in
this manual before proceeding with the installation.
This manual should be retained for future reference.
During installation, it is also important that the
procedures are followed in sequence.
IMPORTANT NOTE
All components, with the exception of the External
Solar Siren are only suitable for internal use.
SYSTEM SECURITY
This system has been designed to both detect intruders
and act as a strong deterrent to would-be intruders.
Please remember that given adequate knowledge and
time it is possible to overcome any alarm system and
we therefore recommend that an Intruder Alarm is used
in conjunction with good physical protection such as
security windows and door locks.
The system is operated by entering an Access Code at
the Control Unit keypad. Protection is provided within
the system to prevent anyone trying to establish your
Access Code by randomly pressing keys on the
keypad. If 16 random keys are pressed the Control Unit
will lock out and 'Bleep' for 15 seconds. If this occurs
3 times without a valid code being entered, a Full Alarm
will occur.
Response
CONTENTS
Installation
SPECIFICATIONS
Protector P500S Wirefree Alarm System
Page No.
1
2
3
3
3
4
4
5
5
5
6
6
6
8
9
10
11
12
12
12
13
13
14
15
15
16
17
19
Back Cover
Advertisement
Table of Contents
