Table of Contents
Advertisement
Control Unit
Anti Tamper Switch
Power Jack Socket
Fuse
OFF
J.D. Link
ON
House Code
Miniature
Switches 1-8
Entry/Exit Delay
Tone Switch 9
Switches 1-8
INSTALLATION
1. Undo the two front cover retaining screws and
hinge the Control Unit cover down.
2. Using the paper template mark the four fixing
holes, ensuring that the template is level. Note that
the bottom fixings are keyhole type, so the holes
should be marked through the top of the keyhole
and that the bottom left hand fixing is behind the
siren transmitter module.
3. Drill the four fixing holes & fully insert the plastic
wall plugs supplied.
IMPORTANT NOTE:
Do not drill the fixing holes with the Control Unit in
position, as the resulting dust could seriously affect
the system electronics and invalidate the guarantee.
4. Insert the two lower screws almost fully in, slide the
Control Unit lower keyhole slots over the screws &
push down into position. Insert the top two screws
& tighten all screws fully ensuring that the unit is
fitted flush & firmly to the wall.
Be careful when fitting the bottom right-hand screw
not to damage the ribbon cable and ensure that the
4
Siren Code
Miniature
Solar Siren
Transmitter Module
Control Unit Siren
control unit sounder plug is plugged into the socket at
the bottom right.
SETTING THE SYSTEM HOUSE CODE
ON
1
2
3
4
House Code
(Always change from the factory setting)
In order to prevent any unauthorised attempt to
activate or disarm your system, you must set your
system to accept encrypted radio signals only
from your own Detectors. This is done by setting a
series of miniature switches in the Control Unit and
Detectors to a special combination selected by
yourself. (Similar to setting a combination lock).
IMPORTANT NOTE:
In order for all detectors to communicate with the
Control Unit, it is essential that the same House Code
View of inside
of Control Unit
Main PCB
Protection Cover
Control Unit
Siren Plug
Ribbon Cable
Entry/Exit Delay Tone
Selection Switch 9
5
6
7
8
9
Protector P500S
Advertisement
Table of Contents
