OmniSwitch Backup Power Shelf/System (BPS)
Installing and Connecting System Power
1
Orient the power supply so that the power cord socket is situated at the right of the power supply. Also,
for the power supply to seat properly, make sure that the handle is in the vertical position.
2
Slide the power supply back until it is securely seated in the chassis backplane.When the connector is
fully seated, the lock tab will click and hold the power supply in place.
3
Plug the power cord (provided) into the power supply's socket.
Note. The chassis does not provide an on/off switch. Connecting a minimum of one system power supply
and one PoE power supply to a power source will power on the OS-BPS chassis and any attached
switches.
OmniSwitch 6860 Hardware Users Guide
May 2014
OmniSwitch BPS Power Connections
page 4-19