Setting Ip Address Information For The Emp - Alcatel-Lucent OmniSwitch 6860 Hardware User's Manual

Getting Started

Setting IP Address Information for the EMP

If installing an Enhanced OS6860 model (OS6860E), the IP address may be set via the Ethernet Management
Port (EMP). To connect to the switch through the EMP Ethernet connection, use the default address below or
change the port's IP address.
Default EMP IP Address
Default EMP Mask
Note. You should be connected to the switch via the console port before attempting to change IP
address information.
To change the default IP and mask, use the ip interface command. For example:
-> ip interface emp address 168.22.2.120 mask 255.255.255.0
Verify your settings using the show ip interface command. See the OmniSwitch AOS Release 8 Switch
Management Guide for additional information regarding EMP port addressing.
Note. Although you have configured the EMP with valid IP address information, you will not be able to
access the switch through this port (i.e. TELNET, FTP, HTTP, SSH or SNMP) until you have unlocked
these remote session types. See
OmniSwitch 6860 Hardware Users Guide
192.168.1.1
255.255.255.0
"Unlocking Session Types" on page 2-8
May 2014
Your First Login Session
for more information.
page 2-7