Step 6:- Device Programming And Installation; Step 7:- Assigning Radio Devices; Step 8:- Adding All Devices To The Control Panel - EMS FIRECELL Programming Manual

Step 6:- Device Programming and Installation

Radio Devices can be programmed to their relevant RCC prior to their installation. The
devices must be powered up and then added to their relevant RCC's by pressing their log
on buttons. For more information about these devices see the Device Power, Logon &
Ident Orientations section.
From Front Display
Addr 003
New Addr L1 A003.
The device has now been added to the Radio Hub and should be installed in its location
prior to the next step of assigning the device to its relevant RCC.
device's installation instructions for more information.

Step 7:- Assigning Radio Devices

The newly added devices must now be assigned. This can be achieved by selecting;
From Un-Assigned Dev
Done 003 of 003 (once complete).

Step 8:- Adding all Devices to the Control Panel

The Radio Hub, RCC's and all radio devices must now be added to the control panel
ensuring the Loop number and addresses programmed at the Radio Hub correspond to
that programmed at the Control Panel.
•
Ensure write switch is set to enable.
•
Turn the key switch to the enabled position.
•
Press the
•
Press the
•
Press the
•
Now to enter the pin number, press the
•
Press the 'Enter' button to enter the pin.
•
Enter the 'Edit Config' menu with the
•
Press the Arrow to scroll down the menu until 'Add device' is highlighted.
•
Press the
•
Press the &
•
Press the
•
Press the &
•
Press the Arrow to select the address required.
•
Press the &
shown.
•
Press the 'Enter' Button to enter. Confirmation of the addition to the system should now
be shown.
•
Once complete, press the 'Exit' button to exit the menu.
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Technical Helpline Tel: +44 (0) 8712 710804
System Programming Manual (Rev2 iss4)
Add New Device
Add By Log On Press Dev Log On followed by Add Dev 03456 Y?
To Exit
Assign Device
button to enter the menu.
Arrow to scroll down the menu until 'Access Level 3' is highlighted.
Arrow to enter the menu.
button to enter the menu.
buttons to highlight the desired loop number for the device.
button to select the loop required.
buttons to scroll through the available address numbers.
buttons to scroll through the device types until the desired device type is
Email:
Select Desired RCC 01
Dev 000 of 003 changing to
To Exit
button four times (thus entering 3333).
button.
enquiries@emsgroup.co.uk
Set Loop 1
See the relevant
Website:www.emsgroup.co.uk
12