Wireless Manual Call Point (Apollo Front)
Installation Guide
REMOVE LABEL ON COMMISSIONING
1 Pre installation
Installation must conform to applicable local installation codes
!
and should only be installed by a fully trained competent person.
•
Ensure that the device is installed as per the site survey.
•
The use of a non-metallic spacer should be considered if mounting the
device on to a metal surface.
•
Do NOT Press the Log On button on a pre-programmed device, as this
will cause communication with the Control Panel to be lost. Should this
happen, delete the device from the system and add it back on.
•
This device contains electronics that may be susceptible to damage
from Electrostatic Discharge (ESD). Take appropriate precautions when
handling electronic boards.
3 Fix mounting plate
•
Remove the mounting plate from the wireless call point. See Step 5 for
more information on unlocking the device.
•
Ensure mounting plate is fitted in the orientation shown.
•
Use both mounting holes.
•
Use suitable fasteners and fixings.
5 Device locking
•
To open the call point, loosen
the fixing screw, then slide the
call point up, away from the
mounting plate.
•
When reassembling, observe the
hinged connection located on
the devices top edge first, prior
to closing the unit. Finally lock
the call point into the mounting
plate by tightening the fixing
screw.
©2022 EMS Ltd. All rights reserved.
REMOVAL
RESET
67 mm
57 mm
Fixing screw
Bottom view of
device
Part no
FC-200-003
2 Components
1
1
Reset key,
4
Wireless call point,
4 Power device
•
When fitting / replacing batteries; observe correct polarity, using only
specified batteries.
•
Connect the power jumper across the PIN header.
(both pins linked)
•
Once powered, reassemble the device.
6 Configuration
The device's loop address is configured within the user interface's menu
structure.
•
Refer to the programming manual for full programming details.
FireCell = MK98
Fusion = TSD062
WZM = TSD143
Free to download from
www.emsgroup.co.uk
Page 1 of 2
Description
Wireless Manual Call Point (Apollo Front)
2
4
3
2
Transparent cover,
3
Fixing screw,
5
Mounting plate
device
SIZE AA
unpowered
(pins unlinked)
SIZE AA
SIZE AA
device
SIZE AA
powered
SIZE AA
MK289-99 Issue 4 21/06/2022 AJM
5