Quick Step By Step Guide To System Programming; Step 1:- Control Panel & Radio Hub Installation; Step 2:- Allocate Hub Radio Communication Channels - EMS FIRECELL Programming Manual

2.0 QUICK STEP BY STEP GUIDE TO SYSTEM PROGRAMMING

The programming step by step guide provides a recommended procedure into the installation and
programming of the EMS FireCell Radio System.
Before commencing with the installation the survey report should be available detailing where the
control panel and radio infrastructure is to be fitted.
Ensure the correct equipment is to be fitted at the designated location, see Equipment
Familiarisation section.
Ensure the Loop and Address numbers which are to be allocated to the devices and radio control
equipment are known as they are required when programming. The Radio Hub defaults to Loop 1
Address 1, if this is to be changed then see Set Hub Address within the Menu Explanation section.
When using the quick guide the following symbols are shown for the internal controls on the
Radio Hub. All programming is undertaken for the system at the Radio Hub.
Step 1:- Control Panel & Radio Hub Installation
The Control Panel and the Radio Hub must be installed in their designated locations.
Installation instructions are supplied with each unit and should be followed.

Step 2:- Allocate Hub Radio Communication Channels

The Radio Channels used to communicate between the Radio Hub and the RCCs are
factory set. It is recommended that they are re-configured to suit the sites environment.
This must be carried out before any RCC'S are added to the system.
From Front Display
Are You Sure Y?
followed by Auto Ch 01 Ch 32.
Note: The longer the duration selected for the Scan Time then the more accurate the results will
be. Available times are between 1-60 minutes, for more information see Radio Channels
within the Menu Structure section.
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Technical Helpline Tel: +44 (0) 8712 710804
System Programming Manual (Rev2 iss4)
= Turn & Press Rotary Button to select relevant menu option.
= Press the Back Button to exit the menu.
Radio Channels
Scan Time 1min
To Exit
Email: enquiries@emsgroup.co.uk
RCC RCC Ch Auto Select
Decrementing Timer
Website:www.emsgroup.co.uk
10