Control Panel Programming - EMS firecell Setup Manual

6 Control Panel Programming

Program the Control Panel; ensuring Loop number and addresses programmed at
the Radio Hub correspond to that programmed at the Control Panel.
Ensure write switch is set to enable.
Turn the key switch to the enabled position.
Press the
2
3
Press the button to scroll down until 'Access Level 3' is highlighted.
Press the
2
Now to enter the pin number, press the
Press the 'Enter' button to enter the pin.
Enter the 'Edit Con g' menu with the
3
Press the button to scroll down the menu until 'Add device' is highlighted.
Press the
2
Press the &
1
Press the
2
Press the &
1
Press the
2
Press the &
1
required type is shown.
Press the 'Enter' Button to enter. Con rmation of the addition to the system
should now be shown.
Once complete, press the 'Exit' button to escape the menu.
button to enter the menu.
button to enter the menu.
button to enter the menu.
3
buttons to highlight the desired device loop number.
button to select the loop required.
3
buttons to scroll through the available address numbers.
button to select the address required.
3
buttons to scroll through the device types until the
3
button four times (entering 3333).
button.
2
8