Software V; Add New Device; Assign Device; Remove Device - EMS FIRECELL Programming Manual

Software V**.**

This displays the devices software version.
Front Display Device Status

5.2 Add New Device

This menu allows all radio device types to be added to the system. The function allows the device
to be added using either the log on button situated on the device or by programming the devices
unique identification number into the Radio Hub via the Rotary Controls.
number associated for the device along with the devices allocated Radio Cluster Communicator
are also allocated at this stage of adding the device to the system. Note: The number of Loops
available to be programmed will depend upon the type of Radio Hub. Available variants are 1, 2
and 4 Loop Radio Hubs. A guide to adding devices is shown in the 'Quick Step by Step Guide To
System Programming' section of this manual.
Front Display Add New Device

5.3 Assign Device

This menu assigns
Communicators. This must be performed once a device has been added to the system and the
device has been installed in its correct location.
Front Display Assign Device

5.4 Remove Device

This section allows radio devices to be removed from the system. A list of devices already
allocated to the system are shown, these can be scrolled through by turning the rotary control.
When the device required to be removed is shown on the display the rotary control can be pushed
to select this device. This will show the devices unique identification number, if correct, selecting
'Yes' will remove the device from the system.
Front Display Remove Device

5.5 Hub/RCC Options

This menu allows access to the configuration of the Radio Hub and Radio Cluster Communicators.
Front Display Hub/RCC Options

Set Hub Address

This section allows the Radio Hub to be allocated to a particular loop and Loop Address number.
As default the Radio Hub will be set as device address 001 on loop 1. Note: Only on 2 or 4 loop
hubs, will allocation to Loop numbers 2,3 or 4 be allowed.
Front Display Hub/RCC Options

Add RCC

This section allows a Radio Cluster Communicator (RCC) to be added to the system. The function
allows the unit to be added using either the log on button situated on the unit or via the devices
unique identification number. The associated Loop number i.e. 1-4, Loop address number for the
RCC and its signal path are all programmed within this menu. Note: Only on 2 or 4 loop hubs, will
allocation to Loop numbers 2,3 or 4 be allowed.
Front Display Hub/RCC Options

Remove RCC

This section allows an RCC to be removed from the system. A list of RCC's already allocated to
the system are shown, these can be scrolled through by turning the rotary control. When the
RCC requiring removal is shown on the display, the rotary control can be pushed to select this
device. Once the rotary control has been rotated to display 'Remove Device Yes', pressing the
rotary control will remove the RCC from the system.
NOTE: RCC's can only be removed from the system when no devices are allocated to that
particular RCC.
Front Display Hub/RCC Options
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Technical Helpline Tel: +44 (0) 8712 710804
System Programming Manual (Rev2 iss4)
Select Desired Device No
any unassigned radio
Set Hub Address
Add RCC
Remove RCC
Email:
Software V**.**
devices to their
enquiries@emsgroup.co.uk
The Loop address
associated Radio Cluster
Website:www.emsgroup.co.uk
24