Motorola AP-7131 Product Reference Manual page 54

2-12 AP-7131 Access Point Product Reference Guide
CAUTION The procedure described in this section is exclusively for wall mount
!
1. Xerox copy the template (on the previous page) to a blank piece of paper. Do not reduce or
enlarge the scale of the template.
2. Tape the template to the wall mounting surface.
• If the installation requires the antenna be positioned vertically, the centerline reference
(of the template) needs to be positioned vertically. The cabling shall exit the access point
in a vertical direction.
• If the installation requires the antenna be positioned horizontally, the vertical centerline
(of the template) needs to be positioned horizontally. The cabling shall exit the access
point in a horizontal direction.
3. At mounting targets A and B, mark the mounting surface through the template at the target
center.
4. Discard the mounting template.
5. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall
mounting screw and stop when there is 1mm between the screw head and the wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going
directly into the wall and 6mm (0.23in.) if wall anchors are being used.
6. If required, install and attach a security cable to the AP-7131 lock port.
7. Attach the antennas to their correct connectors.
For more information on the antennas available to the AP-7131, see
page 2-4.
8. Place the large center opening of each of the mount slots over the screw heads.
9. Slide the AP-7131 down along the mounting surface to hang the mount slots on the screw
heads.
CAUTION Ensure you are placing the antennas on the correct connectors
!
installations.
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the AP-7131.
Antenna Options on