Configuring Security Options - Motorola AP-7131 Product Reference Manual

6-2 AP-7131 Access Point Product Reference Guide
NOTE Security for the access point can be configured in various locations

6.1 Configuring Security Options

To configure the data protection options available on the access point, refer to the following:
• To set an administrative password for secure access point logins, see
page 6-3.
• To display security policy screens used to configure the authetication and encryption
schemes available to the access point, see
on page
• To create a security policy supporting 802.1x EAP, see
Authentication on page
• To define a security policy supporting Kerberos, see,
page 6-8.
• To create a security policy supporting WEP, see
• To configure a security policy supporting KeyGuard, see,
on page
• To define a security policy supporting WPA-TKIP, see
page 6-21.
• To create a security policy supporting WPA2-CCMP, see
on page
• To configure the access point to block specific kinds of HTTP, SMTP and FTP data traffic, see
Configuring Firewall Settings on page
• To create VPN tunnels allowing traffic to route securely through a IPSEC tunnel to a private
network, see
• To configure the access point to block transmissions with devices detected as Rogue AP's
(hostile devices), see
throughout the access point menu structure. This chapter outlines the
security options available to the access point, and the menu locations and
steps required to configure specific security measures.
6-5. These security policies can be used on more than one WLAN.
6-11.
6-18.
6-24.
Configuring VPN Tunnels on page
Configuring Rogue AP Detection on page
Enabling Authentication and Encryption Schemes
Configuring 802.1x EAP
Configuring Kerberos Authentication on
Configuring WEP Encryption on page
Configuring KeyGuard Encryption
Configuring WPA/WPA2 Using TKIP on
Configuring WPA2-CCMP (802.11i)
6-27.
6-36.
Setting Passwords on
6-55.
6-16.