Motorola AP-7131 Product Reference Manual page 56

2-14 AP-7131 Access Point Product Reference Guide
The mounting tools (customer provided) and hardware required to install the AP-7131 on a ceiling
T-bar consists of:
• Safety wire (recommended and customer supplied)
• Security cable (and customer supplied)
To install the AP-7131 on a ceiling T-bar:
1. Motorola recommends you loop a safety wire—with a diameter of at least 1.01 mm (.04 in.),
but no more than 0.158 mm (.0625 in.) —through the tie post (above the AP-7131's console
connector) and secure the loop.
2. If desired, install and attach a security cable to the AP-7131 lock port.
3. Attach the radio antennas to their correct connectors.
For more information on the antennas available to the AP-7131, see
page 2-4.
4. Cable the AP-7131 using either the AP-7131 Power Injector solution or the AP-7131
approved power supply.
CAUTION Do not supply power to the AP-7131 until the cabling of the unit is
!
For Power Injector installations:
a. Connect a RJ-45 CAT 5 Ethernet cable between the network data supply (host) and the
Power Injector Data In connector.
b. Connect a RJ-45 CAT 5 Ethernet cable between the Power Injector Data & Power Out
connector and the AP-7131 GE1/POE port.
c. Ensure the cable length from the Ethernet source to the Power Injector and AP-7131 does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The
Power Injector receives power as soon as AC power is applied. For more information on
using the Power Injector, see
For standard 48-Volt Power Adapter (Part No. 50-14000-247R) and line cord installations:
a. Connect a RJ-45 CAT 5 Ethernet cable between the network data supply (host) and the
AP-7131 GE1/POE port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
complete.
AP-7131 Power Injector System on page
Antenna Options on
2-7.