Motorola AP-7131 Product Reference Manual page 74

3-8 AP-7131 Access Point Product Reference Guide
4. Optionally enter the IP address of the server used to provide system time to the access point
within the Time Server field.
NOTE DNS names are not supported as a valid IP address. The user is required
Once the IP address is entered, the access point's Network Time Protocol (NTP) functionality
is engaged automatically. Refer to the access point Product Reference Guide for information
on defining alternate time servers and setting a synchronization interval for the access point
to adjust its displayed time. Refer to
(if necessary) for information on setting alternate time servers and setting a synchronization
interval for the access point to adjust its displayed time.
5. Click the
a. Select the
access point and a larger network or outside world through the WAN port. Disable this
option to effectively isolate the access point's WAN connection. No connections to a
larger network or the Internet will be possible. MUs cannot communicate beyond the
configured subnets.
b. Select the
point's WAN connection. This is useful, if the larger corporate network or Internet
Service Provider (ISP) uses DHCP. DHCP is a protocol that includes mechanisms for IP
address allocation and delivery of host-specific configuration parameters from a DHCP
server to a host. Some of these parameters are IP address, network mask, and gateway.
NOTE Motorola recommends that the WAN and LAN ports should not both be
c. Specify an
series of four numbers expressed in dot notation, for example, 190.188.12.1 (no DNS
names supported).
d. Specify a
available from the ISP for a DSL or cable-modem connection, or from an administrator if
the access point connects to a larger network. A subnet mask uses a series of four
numbers expressed in dot notation. For example, 255.255.255.0 is a valid subnet mask.
to enter a numerical IP address.
WAN tab to set a minimum set of parameters for using the WAN interface.
Enable WAN Interface
This Interface is a DHCP Client
configured as DHCP clients.
IP address for the access point's WAN connection. An IP address uses a
Subnet Mask for the access point's WAN connection. This number is
Configuring Network Time Protocol (NTP) on page 4-41
checkbox to enable a connection between the
checkbox to enable DHCP for the access