Basic Device Configuration - Motorola AP-7131 Product Reference Manual

3-4 AP-7131 Access Point Product Reference Guide
3. Configure the following settings:
• Baud Rate - 19200
• Data Bits - 8
• Stop Bits - 1
• No Parity
• No Flow Control
4. Press <ESC> or <Enter> to access the access point CLI.
5. Enter the default username of "admin" and the default password of "motorola."
As this is the first time you are logging into the access point, you are prompted to enter a
new password and set the county code. Refer to
available countries two digit country code.
6. At the CLI prompt (admin>), type "summary."
The access point's LAN IP address will display.
7. Using a Web browser, use the access point's IP address to access the access point.
8. Refer to
configuration of the access point.

3.4 Basic Device Configuration

For the basic setup described in this section, the Java-based Web UI will be used to configure the
access point. Use the access point's LAN interface for establishing a link with the access point.
Configure the access point as a DHCP client. For optimal screen resolution, set your screen resolution
to 1024 x 768 pixels or greater.
1. Log in using
your new password if it has been updated from default.
NOTE For optimum compatibility, use Sun Microsystems' JRE 1.5 or higher
Basic Device Configuration on page 3-4
admin as the default Username and
(available from Sun's Website), and be sure to disable Microsoft's Java
Virtual Machine if installed.
Country Codes on page A-6
for instructions on the initial (basic)
motorola as the default Password. Use
for a list of each