Covers - Permobil C500 Service Manual

Covers

Removing the seat elevator cover
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 34. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually, see page 30.
2. The seat elevator cover is mounted with four
plastic plugs which can be flipped up using a
screwdriver.
3. Remove the seat elevator cover by lifting it
upwards/forwards.
Fitting
Fit the cover in the reverse order.
Removing the chassis cover
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 34. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually, see page 30.
2. Remove the seat elevator cover, see above.
3. Remove the two knobs on the front edge of
the cover, see fig.
4. Unscrew the knob at the far back of the
chassis cover, see fig.
5. Remove the chassis cover by lifting it
upwards/backwards.
NOTE
If the chair is equipped with lighting, disconnect the rear-light
cabling at the connector fitted on the cabling.
Fitting
Fit the cover in the reverse order.
Removing the front fender
1. Remove the three screws, see fig.
2. Remove the front fender by lifting it
upwards/forwards.
NOTE
If the chair is equipped with lighting, remove the chassis- and
seat elevator cover. Disconnect the front-light cabling at the
connector fitted on the cabling.
Fitting
Fit the front fender in the reverse order.
The seat elevator cover is mounted with
four plastic plugs.
The chassis cover is mounted with two knobs at
the front edge and one knob at the back.
The front fender is mounted with three screws.
7
Covers