Seat Elevator Drive Belt - Permobil C500 Service Manual

Seat elevator drive belt

Removing
1. Remove the seat elevator, see page 31.
2. Loosen the two bolts holding the shaft to the
seat elevator motor. Push the shaft sideways
to slacken the drive belt.
3. Remove the belt from the motor shaft, then
from the toothed wheel on the seat elevator
screw.
4. Fit the new belt using the reverse procedure.
5. Adjust the belt tension as described below.
6. Fit the seat elevator, see page 31.
Adjusting the belt tension
1. Loosen the two bolts near the belt, see fig.
2. Adjust the belt tension by moving the motor
shaft sideways.
3. Tighten the two screws.
4. Check the belt tension. The belt is correctly
tensioned when it can be pressed in 4-5 mm,
see fig.
NOTE
Check that the seat elevator gear plate are firmly attached with
the four screws.
The drive belt tension can be adjusted
after the two bolts have been loosened.
33
Seat elevator drive belt
The seat elevator shaft is
attached by two bolts.
Check that the seat elevator gear plate are
firmly attached with the four screws.