Pilot+ Controller - Permobil C500 Service Manual

Pilot+ controller

Removal
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 34. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually, see page 30.
2. Switch off the main power switch on the control
panel.
3. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 39.
4. Remove the seat elevator cover and the
chassis cover, see page 7.
5. Lift the Pilot+ controller out of its holder,
see fig. 50.
6. Disconnect the electrical connections to the
pilot+ controller, being attentive to their
placement: see figure
NOTE
The Pilot+ controller connectors A and E have the same function.
Cabling from SLS circuit board and control panel can therefore
be switched if desired.
Fitting
Fit the Pilot+ controller in the reverse order.
The Pilot+ controller sits in its container
without fastening screws.
A
B
C
D
E
Pilot+ controller cable connections.
Pilot+ controller
37
Pilot+ controller
A: SLS circuit board
B: Left drive motor
C: Power feed
D: Right drive motor
E: Control panel