Sls Fuse; Charging Fuse - Permobil C500 Service Manual

Circuit breaker and fuses
Circuit breaker and fuses
Replacing the SLS Fuse
The SLS fuse is located in its holder on the top of
the left battery.
1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 39.
3. Loosen the rear end of the chassis cover a little
by unscrewing the knob that holds the cover,
see page 8
4. Open the left battery covers by loosening the
knob that holds the battery cover, and drop
the cover down.
5. Use the battery strap to pull the battery out
just enough to get access to the SLS fuse
holder.
6. Open the cover of the fuse holder by pulling
it straight out.
7. Replace the blown fuse.
8. Close the cover of the fuse holder.
9. Push the battery back in to the chassis.
10. Close the battery cover and tighten the knob
11. Tghten the knob that holds the chassis cover.
12. Put the circuit breaker in the "ON" position;
see page 39.
Replacing the Charging Fuse
The charging fuse is located in it´s holder on the
right side off the chassis, see fig.
1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 39.
3. Remove the seat elevator cover and the
chassis cover, see page 7.
4. Replace the blown fuse.
5. Refit in the reverse order.
Replacing the SLS Fuse.

Charging Fuse.

40
SLS-Fuse.