Permobil C500 Service Manual page 21

Slewing brackets
9. Loosen the rear end of the chassis cover a little
by unscrewing the knob that holds the cover.
10. Open the battery cover on the side in
quesstion by loosening the knobs that holds
the battery cover, and drop the cover down.
11. Remove the slewing bracket, it is fitted with
a bolt with washer.
For removal of the drive motor, see page 28.
Fitting
Fit the slewing brackets in the reverse order.
Tighten the bolt holding the wheel fork in place
with a torque wrench.
Use a torque wrench to tighten the bolt to
11 ft-Ibs (15Nm).
NOTE
Do not use a Pneumatic impact wrench.
Removal/fitting of slewing brackets.
21
Slewing brackets
Slewing bracket attachment.